Sorry, you need to enable JavaScript to visit this website.

Tetra-tert-butyl copper phthalocyanine-based QCM sensor for toluene detection in air at room temperature

TitoloTetra-tert-butyl copper phthalocyanine-based QCM sensor for toluene detection in air at room temperature
Tipo di pubblicazioneArticolo su Rivista peer-reviewed
Anno di Pubblicazione2015
AutoriKumar, A., Brunet J., Varenne C., Ndiaye A., Pauly A., Penza Michele, and Alvisi Marco
RivistaSensors and Actuators, B: Chemical
Volume210
Paginazione398-407
ISSN09254005
Parole chiaveAir quality, Chemical sensors, Copper, Copper phthalocyanine, Field effect transistors, Layered material, Nitrogen compounds, Phthalocyanines, Quality control, Quartz, Quartz crystal microbalances, Room temperature, Sensitive coatings, Temperature compensation, Tertiary butyl groups, Thermal evaporation, Thin films, Toluene, Toluene detection, Transducers, Volatile organic compounds
Abstract

The sensing properties of tetra-tert-butyl copper phthalocyanine (ttb-CuPc) toward toluene at room temperature are reported in this manuscript. Thin films of ttb-CuPc were obtained by thermal evaporation. The similarities between powdered and layered material have been con.rmed by FTIR analysis. Taking into consideration the interactions involved between material and the target gas, Quartz Crystal Microbalance (QCM) was chosen as transducer. The key role of tertiary butyl groups grafted at the periphery of the phthalocyanine ring on toluene sensitivity has been firstly established. Despite reproducible frequency shifts for toluene exposures at the same concentration, sensor drifts were observed and attributed to temperature effects on quartz crystal. Such thermal in.uence on sensor responses has been minimized by short exposure times and temperature compensation on sensor signal. The strong affinity of ttb-CuPc to toluene as compared to other phthalocyanines, the repeatability of sensor responses, the reversibility of involved gas/material interactions, a resolution higher than 10 ppm and a threshold of detection lower than 35 ppm have been established from experiments. The partial selectivity has been also highlighted toward others gases like CO, NO2, H2S and xylene. At last, the relevance of metallo-phthalocyanine thin films as sensitive coatings on QCM devices to detect volatile organic compounds in real-time situation will be discussed. © 2015 Elsevier B.V. All rights reserved.

Note

cited By 12

URLhttps://www.scopus.com/inward/record.uri?eid=2-s2.0-84921521136&doi=10.1016%2fj.snb.2015.01.010&partnerID=40&md5=2ae53b73f276b0f3d3f33e78d8391897
DOI10.1016/j.snb.2015.01.010
Citation KeyKumar2015398